Suzuki Wagon R Manual page 57

1A-8 HEATER AND VENTILATION
LH VEHICLE
RH VEHICLE
INSTALLATION
1) Reverse removal procedure for installation.
2) Adjust cables as follows.
i) Move mode control knob (a), temperature control knob (b)
and fresh air control knob (c) fully in arrow direction as shown
in figure.
ii) Push mode lever (d), temperature lever (e) and door link (f)
fully in arrow direction and fix cable with clamp in position as
shown in figure.
NOTE:
After installing control cables, be sure that control levers
move smoothly and stop at proper position.
3) If equipped with air bag, enable air bag system. Refer to "ENAB-
LING AIR BAG SYSTEM" in "AIR BAG SYSTEM" section.