3B-14 MANUAL RACK AND PINION
STEERING PINION
REMOVAL
1) Remove rack plunger as shown in STEERING RACK PLUNG-
ER.
2) Remove bearing plug with special tool.
Special Tool
(A): 09944-28310
3) Tap on position as shown with plastic hammer (2) to separate
pinion assembly (1) from housing, and remove pinion assembly
(1).
4) Remove oil seal (2) with special tool from pinion bearing plug (1).
Special Tool
(A): 09913-50121
INSPECTION
D Inspect pinion teeth surface (1) for wear or damage.
D Inspect oil seal (2) for damage.
D Inspect O-ring (3) for damage.
D Check rotation condition of bearing and inspect for wear.
If found defective, replace.
INSTALLATION
1) Install new oil seal with special tool to pinion bearing plug (1).
Special tool
(A): 09925-98210