Suzuki Wagon R Manual page 83

1B-24 AIR CONDITIONING (OPTIONAL)
A
COMPRESSOR
REMOVAL
1) RUN engine at idle speed with air conditioning ON for 10 min-
2) Disconnect negative (–) cable at battery.
3) Recover refrigerant from refrigeration system by using recov-
4) Remove front bumper.
5) Remove engine front cover.
6) Disconnect magnet clutch lead wire and undo lead wire clamp.
7) Remove compressor drive belt by loosening tension pulley bolt
8) Disconnect suction and discharge hoses from compressor.
9) Remove compressor with magnet clutch assembly (1) from its
10) If compressor is replaced.
11) Remove compressor mount (1) by loosening mount bolts (2).
2
INSTALLATION
Reverse removal procedure noting the following point.
D If compressor is replaced, pour new compressor oil with the same
amount as that drained from compressor in REMOVAL.
Refer to "REPLENISHING COMPRESSOR OIL" in this section.
D Evacuate and charge system according to previously described
procedure.
1. New compressor
B
2. Removed
compressor
3. Excess oil (A – B)
utes. After that stop the engine.
ery and recycling equipment.
(1) and adjust bolt (2).
NOTE
Cap open fittings immediately to keep moisture out of sys-
tem.
mount by loosening mounting bolts (2).
Drain oil from compressor, and measure its amount.