Suzuki Wagon R Manual page 54

LH handle vehicle
INSTALLATION
Install heater unit by reversing removal procedure, noting the fol-
lowing items.
D When installing each part, be careful not to catch any cable or wir-
ing harness.
D Adjust heater control cable (refer to heater control lever assembly
in this section).
D Fill engine coolant to radiator.
D If equipped with air bag system, enable air bag system. Refer to
"ENABLING AIR BAG SYSTEM" in Section 10B.
BLOWER MOTOR
REMOVAL
1) Disconnect negative (–) cable at battery.
2) Disable air bag system, if equipped.
Refer to DISABLING AIR BAG SYSTEM in Section 10B.
3) Remove column hole cover.
4) Remove clutch pedal assembly (RH steering vehicle) or brake
pedal assembly (1) and accelerator pedal (2) (LH steering ve-
hicle). Refer to "BRAKE PEDAL" in Section 5A and "CLUTCH
PEDAL" in Section 7C.
5) Disconnect blower motor couplers.
6) Remove blower motor (1).
INSPECTION
1) Check continuity between two terminals as shown in figure.
If there is no continuity, replace blower motor.
2) Connect battery (1) to blower motor connector (2) as shown,
then check that the blower motor operates smoothly.
If blower motor operates do not smoothly, replace blower motor.
Reference current data: Approx. 13 – 20 A at 12 V

HEATER AND VENTILATION 1A-5