Suzuki Wagon R Manual page 109

3B-6 MANUAL RACK AND PINION
TIE ROD END
REMOVAL
1) Hoist vehicle and remove wheel.
2) Remove tie rod end nut (1) from steering knuckle.
3) Disconnect tie rod end from knuckle, using puller (1).
4) For ease of adjustment after installation, make marking (1) of tie
rod end lock nut (2) position on tie rod end thread. Then loosen
lock nut (2) and remove tie rod end (3) from tie rod (4).
INSTALLATION
1) Install tie rod end lock nut (1) and tie rod end (2) to tie rod (3).
Align lock nut with mark (4) on tie rod thread.
2) Connect tie rod end to knuckle. Tighten new tie rod end nut (1)
to specified torque.
Tightening Torque
.
(a): 43 N m (4.3 kg-m, 31.5 lb-ft)