Master Cylinder And Brake Booster Components; Master Cylinder Reservoir Removal And Installation - Suzuki 2006 SX4 Service Manual

4A-11 Brake Control System and Diagnosis:

Master Cylinder and Brake Booster Components

CAUTION
!
Never disassemble master cylinder and brake booster. Disassembly will spoil its original function.
If faulty condition is found, replace it with new one.
1
2
3
1. Reservoir
2. Grommet
: Apply brake fluid.
3. Master cylinder
4. Reservoir connect pin
5. Master cylinder fixing nut
Master Cylinder Reservoir Removal and
Installation
CAUTION
!
Do not allow brake fluid to get on painted
surfaces. Painted surfaces will be damaged
by brake fluid, flush it with water immediately
if any fluid is spilled.
Removal
1) Clean outside of reservoir and master cylinder.
2) Disconnect fluid level switch coupler (1) and clamp
(3) from reservoir (2).
12
11
2
5
(a)
4
6. O-ring
7. Brake booster
8. Clevis pin
9. Clip
10. Gasket
S6RW0C4106011
8
7
6
11. Brake vacuum hose
: Be sure to direct location mark (12) to upward as shown in figure.
: 18N⋅m (1.8kgf-m, 13.0 lb-ft)
: 13N⋅m (1.3kgf-m, 9.5lb-ft)
: Do not reuse.
: Apply grease to piston rod
(Grease included in spare parts to master cylinder or brake booster.)
2
1
S6RW0C4106010
10
(b)
9
I7RW01410017-03
3
I7RW01410009-01