Chrysler Conquest 1988 Service Manual page 102

23-74
__~
~~
BODY
- Front Door Handle and Latch
Pant mark I
, Key cylinder
Reed switch
DOOR KEY CYLINDER UNL-OCK SWITCH
(1) Unlock the lock cylinder-by turning the key.
(2) Check the continuity between the terminals.
Condition
Door
lock
cylinder locked
Door lock cylinder u cl
N& -1 I- 1 -
iIi~-i 1 inrilcates that there IS contlnuitv between the terminals.
SERVICE POINTS OF INSTALLATION
15. INSTALLATION OF DOOR LOCK ACTUATOR / 14. ROD
SNAP / 13. DOOR LATCH (WITH DOOR LOCK SWITCH)
(1) Mount the rod snap in the latch lock lever and
mount
the actuator rod to the rod snap.
(2) Fix the actuator rod and latch lock lever in the lock
positlon md tighten tetnporarily the latch mounting
bolts.
(3) Lightly force up (toward the lever) the door lock actuator
and tighten the latch mounting bolts. Tighten-the door
lock actuator mounling bolts.
12. INStALLATlON OF KEY CYLINDER / IO. REED SWITCH
Install the key cylinder and the reed switch as shown with
their paint mark directed upward.
2. INSTALLATION OF WATERPROOF FILM
Refer to P.23-66.