Clear The Bkupmemp Alarm; Bpv; Clear The Bpv Alarm; Carloss - Cisco ONS 15600 SDH Troubleshooting Manual

Chapter 2 Alarm Troubleshooting
The BKUPMEMP alarm can also cause the
caused by BKUPMEMP, complete the following procedure to clear the BKUPMEMP and the EQPT
alarm.
It can take up to 30 minutes for software to be updated on a standby TSC card.
Caution

Clear the BKUPMEMP Alarm

Step 1 Verify that both TSC cards are powered and enabled by confirming lighted SRV LEDs on the TSC cards.
Determine whether the active or standby TSC card that has the alarm.
Step 2
If both TSC cards are powered and enabled, reset the TSC card against which the alarm is raised.
Step 3
Complete the
Wait ten minutes to verify that the card you reset completely reboots.
If the TSC card you reset does not reboot successfully, or the alarm has not cleared, call Cisco TAC (1
Step 4
800 553-2447). If the Cisco TAC technician tells you to reseat the card, complete the
a Card Pull (Reseat)" procedure on page
and reinstall a new one, follow the

2.6.20 BPV

The Bipolar Violation alarm is generated when bipolar violation does not satisfy the requirements
described in ITU-T recommendations.

Clear the BPV Alarm

Check if the input signal is correct and that the externally synchronized node is correctly provisioned
Step 1
with the 64KHz signal.
If the type of signal is correct then check if all two wires are firmly connected to the BITS-IN pins.
Step 2
If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
Step 3
for more information or call Cisco TAC (1 800 553-2447) in order to report a Service-Affecting (SA)
problem.

2.6.21 CARLOSS

The Carrier Loss for Gigabit Ethernet (GE) alarm occurs on ASAP ports supporting Gigabit Ethernet
traffic. The loss can be due to a misconfiguration, fiber cut, or client equipment problem.
July 2010
"Soft-Reset a Card Using CTC" procedure on page
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
Logical Object: BITS
Default Severity: Major (MJ), Service-Affecting (SA)
Logical Object: GIGE
"EQPT (EQPT)" alarm on page
2-133. If the Cisco TAC technician tells you to remove the card
"Replace a TSC Card" procedure on page
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
2.6.20 BPV
2-44. If the EQPT alarm is
2-130.
"Reset a Card with
2-136.
2-27