Single-Port Mode - Altera Cyclone IV Device Handbook

3–8
1
Violating the setup or hold time on the M9K memory block input registers may
corrupt memory contents. This applies to both read and write operations.

Single-Port Mode

Single-port mode supports non-simultaneous read and write operations from a single
address.
devices M9K memory blocks.
Figure 3–6. Single-Port Memory
Notes to
(1) You can implement two single-port memory blocks in a single M9K block.
(2) For more information, refer to
During a write operation, the behavior of the RAM outputs is configurable. If you
activate rden during a write operation, the RAM outputs show either the new data
being written or the old data at that address. If you perform a write operation with
rden deactivated, the RAM outputs retain the values they held during the most recent
active rden signal.
To choose the desired behavior, set the Read-During-Write option to either New Data
or Old Data in the RAM MegaWizard Plug-In Manager in the Quartus II software. For
more information about read-during-write mode, refer to
Operations" on page
The port width configurations for M9K blocks in single-port mode are as follow:
■ 8192 × 1
■ 4096 × 2
■ 2048 × 4
■ 1024 × 8
■ 1024 × 9
■ 512 × 16
512 × 18
■
■ 256 × 32
■ 256 × 36
Cyclone IV Device Handbook,
Volume 1
Figure 3–6 shows the single-port memory configuration for Cyclone IV
(1)
,
data[ ]
address[ ]
wren
byteena[]
addressstall
inclock
inclocken
rden
aclr
Figure 3–6:
"Packed Mode Support" on page
3–15.
Chapter 3: Memory Blocks in Cyclone IV Devices
(2)
outclock
outclocken
3–4.
Memory Modes
q[]
"Read-During-Write
November 2011 Altera Corporation