When Coordinate Axes Rotation Are Set - GRAPHTEC FCX4000 SERIES User Manual

Press the [1] key to set the new origin. Then, the ORIGIN
lamp lights.
In this case, even if turned ON/OFF the power, the set origin
is not cleared.
"The new origin was recorded" message is displayed on the screen for a
few seconds.
[ORIGIN] lamp lights.
If the ROTATE (the coordinates are rotated) or MIRROR
mode is selected or cancelled after the origin point has been
moved, the origin point is reset to its default position.
However, if the [ORIGIN] key is held down, the origin point
is not reset to its default position even when the ROTATE or
MIRROR mode is cancelled.
To reset the newly registered origin point to its default
position, move the cutter pen in the direction towards the
lower left point until it stops, and then either hold down the
[ORIGIN] key or turn on the power while pressing the [ORIGIN]
key.
If you intend to use the ORIGIN function in combination with
the ROTATE of the coordinates or the MIRROR mode, be
sure to set the cutting origin point after setting the ROTATE
of the coordinates or MIRROR mode.

When Coordinate Axes Rotation are Set

If the origin point is moved while the coordinate axes are rotated, the origin point will move as shown below.
Supplement
See "Setting the Cutting Direction" about the rotation of the coordinate axes.
Original origin point
New origin point
3-8
Supplement
•
The ORIGIN setting becomes invalid when
the Registration Mark mode is specified.
•
After a new origin has been set, the
coordinates being displayed on the LCD
represent the distances along the X and Y
axes from the new origin.
•
Please refer to "Chapter 5 Registration
Mark Settings and Detection" for
the origin point after the automatic
registration mark reading function has
been used.