GRAPHTEC FCX4000 SERIES User Manual page 80

3
Press the [COPY] key.
COPY MODE screen is displayed.
4
Press the [1] key (NUMBER OF COPIES).
NUMBER OF COPIES setting screen is displayed.
5
Press the POSITION (
setting value.
6
Confirm the setting value and press the [ESC] key
(PREVIOUS).
Number of copies will be selected, and it will return to COPY MODE
screen.
7
Confirm the setting and press the [ENTER] key (SET).
The plotter starts a copy immediately.
) key and increase or decrease the
4-10
Supplement
•
The CHANGE MEDIA a message is
displayed each time when ending a single
cut.
"If the [ESC] key (CANCEL) is pressed,
copying will be suspended and it will
return to the default screen.
•
If there is no data in the buffer memory,
"There is no data for copying in the
buffer" will be displayed. Please send
cutting data.
•
If too much data is sent from the buffer
memory, "Copy mode buffer is full!" will
be displayed.
Supplement
The copy number can be set from 1 to 100.
Supplement
"CANNOT COPY CUT AREA TOO SMALL!"
is displayed if the cutting area is smaller
than the copy data. Either expand the cutting
area, or set the media that is big enough to
copy.