6.2
Manual Position Adjust
Method of manual position adjust is described here.
Supplement
•
Adjustment will be cleared if the following is done after setting the adjustment.
• Set new origin point.
• Set rotation or mirror. (Set the rotate or mirror prior to the axis adjustment)
•
When the inclination of the axis is too large when setting the first and second point, the first and third point, the third and
fourth point, or the second and fourth point, "Angle adjustment error, please reset" will be displayed. After setting the
media so as to make the inclination small, please perform adjustment operations.
•
Axis adjustment will be cleared when point 1 and point 2 is set to same point.
Operation
1
Load the media with adjustment mark in the plotter
(Refer to the "Loading the Media")
2
Set a cutter plunger or a pen in the tool holder.
3
Press the [PAUSE/MENU] key.
MENU screen is displayed.
4
Press the [2] key (ARMS).
ARMS SETTING screen (1/5) is displayed.
5
Press the POSITION ( ) key.
ARMS SETTING screen (2/5) is displayed.
6-3