Setting the Creasing Mode
When selecting the creasing tool, you can set the spacing, the number of creasing operations and the start and
end positions.
Creasing mode is enabled only when the tool type is set to the creasing tool (CP001, CT-002).
Operation
1
Press the [COND/TEST] key in the default screen.
CONDITION screen (1/4) is displayed.
2
Press POSITION ( ) key twice.
CONDITION screen (3/4) is displayed.
3
Press the [1] key (CREASE CONDITION).
CREASE CONDITION setting screen is displayed.
<Setting the Creasing Mode>
Modes 2 and 3 enable thick media to be bent easily.
Selectable parameters: MODE 1. MODE 2, MODE 3
Actual Data
4
Press the [2] key (CREASE MODE).
CREASE MODE setting screen is displayed.
Mode 1
(Crease one line)
Crease lines at the same position
as the actual data.
2-20
Supplement
Press the [ESC] key (Return) to return to the
CONDITION screen without changing any
settings.
Mode 2
(Crease two lines)
Actual data
Crease lines at positions on either side
of the actual data. (Creasing is not
performed at the actual data position)
Mode 3
(Crease three lines)
Actual data
Crease lines at the same position
as and on either side of the
actual data.