GRAPHTEC FCX4000 SERIES User Manual page 43

5
Select the mode using the POSITION (
[ESC] key.
CREASE setting screen is displayed.
<Setting of Spacing>
Set the spacing between the lines.
Setting range: 0 to 9.99 (mm)
Mode 2
(Crease two lines)
Actual data
(creasing is not performed
at the actual data position)
6
Press [ ] key (SPACING)
SPACING setting screen is displayed.
7
Increase or decrease the setting value using the POSITION
( ) keys and press the [ESC] key.
CREASE setting screen is displayed.
<Setting the number of creasing operations>
This setting determines how many times creasing should be repeated for each line segment.
Setting range: 1 to 9 (times)
8
Press the [3] key (REPEAT).
SPACING setting screen is displayed.
9
Increase or decrease the setting value using the POSITION
( ) keys and press the [ESC] key.
CREASE setting screen is displayed.
) keys and press
Mode 3
(Crease three lines)
Spacing
Actual data
Spacing
Supplement
The spacing parameter is only enabled for
Modes 2 and 3.
2-21