Adjust With 3 Points - GRAPHTEC FCX4000 SERIES User Manual

Adjust with 3 POINTS
3 POINTS adjustment scans 3 registration marks as shown below, where the adjustment is done measuring the
tilting of the X and Y axes and the distance between the registration marks (horizontal and vertical directions).
This adjustment is called 2 axis adjustment (tilt adjustment).
When the set media is inclined with respect to the X-direction as shown in the following figure, the actually
measured position of the registration mark is shifted from the original position. Comparing these coordinates, the
inclination and the distance can be adjusted.
Original registration
Difference in Y
Third registration mark
Operation
1
Load the media with registration marks (3 POINTS) plotted.
2
Set the Registration Mark mode to ARMS, and the number of
registration marks to 3 POINTS.
(See "Setting MARK SCAN Mode and Numbers".)
3
Set the shape and size of the registration mark, mark
distance, distance adjust mode, offset, paper-weight, sensor
level, scan position adjustment, etc., as needed.
(See "Shape (Pattern) of the Registration Mark".)
(See "Setting Registration Mark Size".)
(See "Setting Mark Distance".)
(See "Setting Distance Adjustment Between the Registration Marks".)
(See "Setting Offset Between the Registration Mark and Cutting Origin Points".)
(See "Adjusting the Sensor Level".)
(See "Manually Adjusting the Sensor Level (Threshold Value)".)
4
Press the [PAUSE/MENU] key.
MENU screen is displayed
Difference in X
mark position
Tilt
First registration mark
Difference in Y
Difference in X
Original registration mark position
Tilt
Second registration mark
Supplement
See "Loading Media (Paper or Marking Film)"
for loading the media.
Supplement
It is not necessary to set the MARK
DISTANCE when it is adjusted manually.
5-42