GRAPHTEC FCX4000 SERIES User Manual page 107

10
Press [2] key (SCAN). The following message is displayed.
Following message is displayed
11
Confirm that the tool is at the position shown in the left image
(grey square area), and press the [ENTER] key.
It will scan the registration mark, and then plot the registration mark for
comparison. It will return to SENSOR OFFSET ADJ. screen once the
plotting is completed
Align the tool to this area
12
Using the registration mark for adjustment plotted in step
9, measure the distance of how much the registration mark
for comparison needs to be moved so both will overlap, and
record the value. As an example, in the figure above, it needs
to move in negative directions for both X and Y directions, so
both of the adjustment values will be negative values.
13
Press the [3] key (X).
SENSOR OFFSET ADJ. X screen is displayed.
14
Press the POSITION (
the setting value. Set the X value measured in step 12.
15
Confirm the setting and press the [ESC] key (PREVIOUS).
SENSOR OFFSET ADJ. is selected and it will return to SENSOR
OFFSET ADJ. screen.
) keys and increase or decrease
5-25
Distance adjustment value X
Registration mark
for comparison
Registration mark for
adjustment
Supplement
Position of the registration mark is measured
at the center of the line.
Supplement
Setting range is -2.0 mm to +2.0 mm.
Distance adjustment value Y