Setting The Force - GRAPHTEC FCX4000 SERIES User Manual

Setting the Force

Set the cutting force that is used in each of the condition numbers.
Setting range : 1 to 48
Operation
1
Press the [COND/TEST] key in the default screen.
CONDITION screen (1/4) is displayed.
2
Press the [4] key (FORCE).
FORCE setting screen is displayed.
3
Press the POSITION (
number (CONDITION No.).
4
Press the POSITION (
the setting value.
5
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (1/4).
6
Press the [COND/TEST] key.
It will return to default screen.
) keys and select the condition
) keys and increase or decrease
2-24
Supplement
When "XY FORCE SWITCH" is enabled, the
following screen is displayed.
Using the [2] and [3] keys, move X and Y.
Then, press the POSITION (
increase or decrease the set value.
If different values have been set for X and Y,
the cutting force in the diagonal direction will
be an intermediate value of X and Y values,
and will vary according to the angle.
Force
[Y]
Force
[ ]
*
45°
Force
[X]
("X" force) g + ("Y" force) g
=
*
2
Supplement
You can set between 1 and 48..
) keys and