GRAPHTEC FCX4000 SERIES User Manual page 96

4
Press the [2] key (REGISTRAION MARK).
REGISTRAION MARK TYPE setting screen is displayed.
5
Press the [1] key (TYPE 1), the [2] key (TYPE 2), the [3] key
(TYPE 3), or the [4] key (TYPE 4)
When the TYPE 1 or 2 is selected, pressing the ( ) key can
switch the REVERSE REGISTRATION MARK to ON/OFF.
When the TYPE 3 is selected, the pacing and center (center
registration mark) are set.
When the TYPE 4 is selected, the pacing is set.
MARK TYPE 3
Setting value
The center registration mark can only be scanned for
registration mark pattern 3, when the number of registration
marks is 2POINTS or 3POINS and only when "USER" has
been selected.
Enter the distance from the registration mark scanning area
in the W.
In the case shown in the figure below, the W is a negative
value.
6
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to ARMS SETTING screen (2/5).
7
Press the [PAUSE/MENU] key
It will return to the default screen.
<Spacing>
MARK TYPE 4
Setting value
<Center registration mark (CENTER)>
Vertical line Horizontal lineSet
Set the W within the
there are no vertical or horizontal lines.
Supplement
•
It will return to ARMS SETTING screen
(2/5) without changing the settings when
you press the [ESC] key (CANCEL).
•
The REVERSE REGISTRATION MARK to
ON setting is canceled when the power is
turned off.
Supplement
For the registration marl patterns, see
"Outline of ARMS".
Supplement
Spacing range is 0 to 9.9 (mm).
The W value range of the center registration
mark (CENTER) is -99.9 to +99.9 (mm).
range in which
Supplement
It will return to ARMS SETTING screen (2/5)
without changing the settings when you
press the [ESC] key (CANCEL).
5-14