GRAPHTEC FCX4000 SERIES User Manual page 93

4 axes adjustment (4POINTS sensing)
Supplement
•
Distance between the registration marks can be adjusted.
•
Multiple registration marks (Alignment registration mark) is available. (See the "Multiple registration marks [Alignment
registration mark] ")
•
The printable range on the figure below is for when the Mark Distance is not specified.
The cutting area changes depending on the Mark Distance that is set.
It will sense the left and right vertical tilts and upper and lower horizontal tilt from 4 registration marks, and cut is
performed matching the tilt of the print.
Precision of print and cut position will be higher than the 2 axes adjustment.
MARK TYPE MIRROR 1
Multiple registration marks (Alignment registration mark)
Supplement
•
Setting is only possible from the Application software.
•
It cannot be set on the plotter.
A function to continuously cut the print with same design aligned, using a plugin for the Illustrator. It is appropriate
for cutting multiple numbers of stickers or similar.
MARK TYPE 1
MARK TYPE MIRROR 2
Cutout area
Printable area
MARK TYPE 2
Cutout area
5-11
MARK TYPE 3
MARK TYPE 4