GRAPHTEC FCX4000 SERIES User Manual page 73

3
Press the POSITION ( ) key.
AREA PARAMETERS screen (2/2) is displayed.
4
Press the [1] key (AREA).
SET LOWER LEFT screen is displayed.
5
Press the POSITION (
carriage to the position to be the lower left of the AREA.
6
Press the [ENTER] key (SET) once the tool carriage is in
correct position.
SET UPPER RIGHT screen is displayed.
7
Press the POSITION (
carriage to the upper right position of the AREA.
8
Press the [ENTER] key (SET) once the tool carriage is in
correct position.
Setting will be set, and it will return to AREA PARAMETER screen (2/2).
9
Press the [PAUSE/MENU] key.
It will return to default screen.
) keys and move the tool
) keys and move the tool
4-3
Supplement
•
Coordinate value displayed here is the
distance to the tool carriage from the
origin point.
•
Press [1] key (DEFAULT) if the cutting are
is not to change.
Supplement
Please set the X and Y cut range for the
areas on the upper right and lower left points
to at least 10 mm.
An error message will appear for areas that
are too small.
You will need to reset the settings for the
upper right and lower left points.
Supplement
It will return to AREA PARAMETERS screen
(2/2) without changing the settings when you
press the [ESC] key (CANCEL).