Chapter 3: Basic Operations - GRAPHTEC FCX4000 SERIES User Manual
Cutting plotter
Hide thumbs
Also See for FCX4000 SERIES:
- Setup manual (12 pages) ,
- Service manual (197 pages) ,
- Setup manual (16 pages)
Table of Contents
Advertisement
Chapter 3: Basic Operations
This chapter describes the basic methods to operate the plotter manually.
All the operations described in this chapter is to start from the READY status (media is set) as a general condition.
Perform the operation described in this chapter after making the plotter in READY status referring to previous
chapter.
PRODUCT SUMMARY
3.1
Raise or Lower the Tool
3.2
Move the Tool Carriage
3.3
Setting the Origin Point
3.4
Setting the Cutting Direction
3.5
Stop Cutting
3-1
Advertisement
Table of Contents
Troubleshooting
