GRAPHTEC FCX4000 SERIES User Manual page 121

6
Press the [2] key (TEST ARMS SENSOR ).
TEST ARMS SENSOR screen is displayed.
7
Press either the [1] key (TYPE 1) or the [2] key (TYPE 2)
depending on the type of the registration mark to be used.
The following message is displayed.
8
Move the tool to the position to start scanning of the
registration mark by pressing the POSITION (
MARK TYPE 1
Move the tool inside this
area
9
Confirm the position of the tool and press the [ENTER] key.
The plotter will automatically sense the registration mark and cut the
peak of each registration marks
10
Confirm the cutting result.
See "Adjusting for the Registration Mark Scan Position" and adjust if the
cutting position is shifted. See "Adjusting the Sensor Level" and adjust if
the registration mark cannot be scanned.
Registration mark scanning area
Supplement
It will return to ARMS SETTING screen (5/5)
without changing the settings when you
press the [ESC] key (CANCEL).
Supplement
It will return to ARMS SETTING screen
(3 /5) without changing the settings when
you press the [ESC] key (CANCEL).
) keys.
MARK TYPE 2
Move the tool inside this
area
Supplement
Following error is displayed when the
registration mark was not scanned properly.
Press the [1] key (RETRY) to scan again, or
the [ESC] key (CANCEL) to exit.
5-39