Confirming The Cutting Data - GRAPHTEC FCX4000 SERIES User Manual

14.5
Confirming the Cutting Data
Output of the dump list of the cutting data received by the plotter is possible. It is used to check if the transmission
of cutting data is performed correctly.
CAUTION
Do not place your hand around the moving areas. The tool carriage will start moving, so there is a chance of injury. Tool
carriage will start to move immediately after selecting to print the dump list.
Supplement
•
There may be a difference in the RS-232C transmission condition or the command setting when the printed output and the
display of transmission data does not match. Check the transmission condition and the command.
•
If the command setting is "Auto", the dump list of the cutting data is not output. Please set the command to "GP-GL" or
"HP-GL".
Operation
1
Set a media larger than A4 size.
2
Set the pen tool to the tool holder and select the condition
where the pen tool is set.
3
Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
4
Press the POSITION ( ) key (TEST).
TEST menu screen (1/2) is displayed.
Supplement
See "Loading Media " for loading the media.
Supplement
•
•
14-21
See "Attaching a Tool" for setting the pen
tool.
For changing the tool conditions please
refer to "Selecting Tool Condition", and
for tool settings please refer to "Setting
the Tool".