Attaching A Tool - GRAPHTEC FCX4000 SERIES User Manual

2.2

Attaching a Tool

Attach a tool to the cutting plotter.
Attaching a Tool
When mounting the tool in the tool holder, please note the following.
•
Push the tool all the way into the holder until its flange contacts the upper part of the holder and then tighten
the screw firmly.
•
To prevent injury, avoid absolutely touching the tool immediately after the cutting plotter is turned on or
whenever the tool is moving.
It is explained here using cutter plunger as an example.
CAUTION
When pushing the tool holder with your fingers, the blade tip may be protruding. Take care not to cut your fingers.
Mounting
1
Loosen the tool holder screw.
Bracket to hold tool
Tool holder
Tool holder screw
Tool holder 2
Tool holder 1
Registration mark sensor
Bracket to hold tool
Tool holder
Tool holder screw
2-5