GRAPHTEC FCX4000 SERIES User Manual page 160

6
Press the [2] key (TEST PATTERN).
The following message is displayed.
7
Press the POSITION (
to the position to plot a test pattern.
Be sure to move it inside of a plotting range greater than 50
mm on both the X and Y axes.
8
Confirm the tool position and press [ENTER] key.
Plot a "+" sign with the Tool 1.
Next, plot a "+" sign with the Tool 2.
After the plotting is completed, the TOOL OFFSET ADJ setting screen is
displayed.
9
Measure how much the "+" plotted with the Tool 2 is out of
alignment with the reference "+" plotted with the Tool 1.
(For example, in the following figure, input X = +a mm and
Y = -b mm, since it's out of alignment in the negative X-axis
and the positive Y-axis)
"+" plotted with Tool 2
Y mm
10
Press [3] key (X=+0.0 mm).
TOOL OFFSET ADJ (X) setting screen is displayed.
) keys to move the tool carriages
b
a
"+" plotted with Tool 1
X mm
Supplement
•
Press the [ESC] key (Return) to return to
the TOOL OFFSET ADJ setting screen
without changing any settings.
•
Pressing simultaneously the [POSITION]
and [SLOW] keys moves the tool carriage
slowly.
7-24