GRAPHTEC FCX4000 SERIES User Manual page 78

It will copy in following order when COORDINATE AXES ROTATION is set.
Copy origin point
First cut
Origin point
Fifth copy
Operation
1
Create one cutting data you want to copy.
Cutting data is stored in the buffer memory.
2
Press the POSITION (
carriage to the position to copy.
3
Press the [COPY] key.
COPY MODE screen is displayed.
4
Press the [1] key (NUMBER OF COPIES).
NUMBER OF COPIES setting screen is displayed.
5
Press the POSITION (
setting value.
Third copy
First copy Second copy
Copy space
Copy space
Sixth copy
) keys and move the tool
) key and increase or decrease the
Fourth copy
Supplement
•
•
•
Supplement
•
•
4-8
"NO DATA FOR COPY IN BUFFER!" is
displayed if there is no data in the buffer
memory. Send the cutting data.
If too much data is sent from the buffer
memory, "Copy mode buffer is full!" will
be displayed.
If the data to be copied is larger than the
cutting area, "Cannot copy, the valid area
is too small" will be displayed.
Number of copies can be set up to the
number of loaded media.
The initial value for the number of copies
is always 1.