When Cut Results Are Poor - GRAPHTEC LABERLROBO DLC1000 User Manual

When Cut Results Are Poor

Symptom
The cut corners are rounded or too
pointed.
The cut line starts out crooked.
The blade skips and does not
completely cut lines that should be
solid.
Solid lines are not cut at a constant
depth. (Slight skipping of the blade)
Coarse resolution of curved lines.
The cutting medium curls up at the
corners.
The cutter blade is cutting into the
backing sheet.
The cutter blade has fallen out of the
cutter plunger.
The medium can be cut but is hard to
weed afterward.
Abnormal noise generated by the
cutter plunger during cutting.
The medium is discolored where the
cutter blade has passed.
The setting value of CUT CONDITION
cannot be maintained.
The setting value of CUT CONDITION
cannot be changed.
Media is bowed.
cut. (slight distance error)
The starting and end points do not
match.
Cause
The OFFSET is incompatible with the
cutter blade being used.
There is abrasion of the blade.
The cutter blade does not rotate
smoothly.
The Offset Cut Pressure is too low.
The cutter blade is extended too far.
The cutting SPEED is too high.
The output data resolution is too low.
The cutter blade is extended too far.
The OFFSET is incompatible with the
cutter blade being used.
The cutting SPEED is too high.
The blade is dull.
The cutter blade is extended too far.
The cutting FORCE is too high.
The cutter blade is the incorrect
diameter for the plunger.
The spring of the cutter blade
(CB09UA) has fallen out.
The medium gets entangled during
cutting.
The medium is stuck in the tip of the
plunger.
after a setting was changed.
The media is set at a slant.
The distance adjustment value is not
appropriate.
The data is not connected.
The backing sheet is too soft.
Cutter blade rotation is not smooth.
The life of the cutter plunger.
6-4
Solution
Adjust the OFFSET value of CUT
CONDITION.
Match the setting to the blade being
used.
> If it is too low, the corners become
rounded.
> If it is too high, the corners are too
pointed.
Replace the cut blade.
Remove any foreign matter inside the
holder.
Raise the Offset Pressure setting.
(The Offset Pressure is separate from
the cutting FORCE)
Adjust the blade length.
Reduce the SPEED setting value of
CUT CONDITION.
Increase the output data resolution.
Adjust the blade length.
Change the OFFSET setting value of
CUT CONDITION.
Reduce the SPEED setting value of
CUT CONDITION.
Adjust the blade length.
Or, replace the cutter blade with the
new one.
Adjust the blade length.
Reduce the FORCE setting value of
CUT CONDITION.
Use a cutter blade that matches the
plunger's diameter.
Replace the cutter blade with a new
Reduce the blade length.
Reduce the FORCE setting value of
CUT CONDITION.
Adjust the blade length and the
FORCE of CUT CONDITION.
Make sure you are setting the
conditions correctly.
Correct the setting of the media.
Specify the appropriate distance
adjustment value.
Verify the data in the application.
Change to media with a hard backing
sheet.
Verify that refuse, etc. is not stuck on
the blade.
Replace the cutter plunger with new
one.