17
Press the POSITION (
18
Confirm the setting and press the [ESC] key (PREVIOUS).
UP MODE will be set and it will return to CUT LINE CONDITION screen.
19
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (3/4).
20
Press the [PAUSE/MENU] key.
It will return to the default screen.
) keys and set the UP MODE.
7-17
Supplement
•
The value set here is the FORCE at the
part that is not cut. When "UP" is set, the
tool up is started.
•
By entering the smaller value than the
FORCE at the time of the normal cut, the
half cut is performed.
Supplement
It will return to CONDITION screen (3/4)
without changing the settings when you
press the ESC key (CANCEL).