Daily Maintenance; Storing The Cutting Plotter - GRAPHTEC FCX4000 SERIES User Manual

13.1

Daily Maintenance

Daily Maintenance
During the course of daily maintenance be sure to observe the following precautions:
(1) Never lubricate the mechanisms of the plotter.
(2) Clean the plotter's casing using a dry cloth that has been moistened in a neutral detergent diluted with water.
Never use thinner, benzene, alcohol, or similar solvents to clean the casings; they will damage the casing's
finish.
* Please be careful so that the neutral detergent does not adhere to the writing panel. If the neutral detergent
adheres, electrostatic adsorption decreases or disappears.
(3) If the writing panel is dirty, please clean using a dry cloth.
* Do not use benzine, thinners, or similar solvents to clean the writing panel.
(4) When the Y rail sliding surface gets dirty, gently wipe the dirt away with a clean, dry towel.
* The sliding surface has lubricant on it, so be sure not to wipe all the lubricant off as well.

Storing the Cutting Plotter

When your cutting plotter is not in use, be sure to observe the following points:
(1) Remove the tool attached to the tool holder.
(2) Cover the cutting plotter with a cloth to protect it from dust and dirt.
(3) Do not store the cutting plotter in direct sunlight or in high temperatures.
13-2