7.5
Setting Cut Line
After turning on the power or changing pen condition settings, touch the blade to the media and adjust the blade
direction.
The processing in the part is not cut with perforation patter is adjusted in "UP MODE".
The perforation setting can be set for each condition number.
Supplement
•
Normally use it with default value OFF. It will cut with solid line.
•
Doing a cut-out (cutting out) with a perforated setting instead of a normal film cut (half cutting) can damage the writing
panel and the quality of a normal cut.
Operation
1
Press the [COND/TEST] key.
CONDITION screen (1/4) is displayed.
2
Press the POSITION ( ) key twice.
CONDITION screen (3/4) is displayed.
3
Press the [3] key (CUT LINE CONDITION).
CUT LINE CONDITION setting screen is displayed.
7-14