Cutting area when adjusting the regisitaration mark
Even when adjusting the regisitaration mark, you can cut the outside
of the registration mark (cutting area).
MARK TYPE 1
MARK TYPE MIRROR 1
Cutout area
Media
Cutting area (same as the area after scanning the registration mark)
Automatic sensed of registration mark position
The registration mark is sensed within area A from the registration mark scanning start position (tool position).
When the registration mark is not sensed within the area A, then within area B is sensed. Only when the
registration mark is present in area A or B, it is possible to recognize as the mark.
Registration mark scanning start position
100
100
MARK TYPE 2
MARK TYPE MIRROR 2
Cutout area
Unit: mm
5-6
Supplement
If the distortion due to the adjustment is
large, there is a possibility that the cutting
area is reduced.
MARK TYPE 3
MARK TYPE 4