Nomenclature - GRAPHTEC FCX4000 SERIES User Manual

1.2

Nomenclature

(10) Network interface
connector
(8) USB interface connector
(9) RS-232C interface connector
(1) Control panel .................................Used to access various cutting plotter functions.
(2) Power switch .................................Used to turn the cutting plotter on and off.
(3) AC line inlet ...................................Inlet where the power cable is connected.
(4) Writing panel .................................Cutting/Plotting/Creasing work is performed on the panel.
(5) CHART HOLD key ........................Lamp lights up when the [CHART HOLD] key is pressed, you can see
(6) Tool carriage .................................Part to drive the cutter/pen.
(7) Y bar .............................................Holds the tool carriage; moves left/right.
(8) USB interface connector ...............Used to connect the cutting plotter to the computer with a USB interface
(9) RS-232C interface connector .......Used to connect the cutting plotter to the computer with a RS-232C
(10) Network (LAN) interface connector ..The connector used when connecting this cutting plotter with the
(11) USB memory dedicated port .......The port that is used only for the USB memory.
(7) Y bar
(6) Tool carriage
(5) CHART HOLD key
(11) USB memory (1) Control panel
dedicated port
that the electrostatic adsorption is functioning. Lamp is turned off by
pressing again, the electrostatic adsorption is released.
cable.
interface cable.
network (LAN)interface cable.
(4) Writing panel
1-3
(3) AC line inlet
(2) Power switch