4
Press the POSITION ( ) key twice.
ARMS SETTING screen (3/5) is displayed.
5
Press the [4] key (SENSOR ADJUST).
SENSOR ADJUST screen is displayed.
6
Press the [1] key (SCAN).
The following message is displayed.
7
Press the POSITION (
carriage to the area to start scanning of the registration mark.
Registration mark scan area
Align the tool to this area.
8
Confirm the position of the tool, and if it is OK, press the
[ENTER] key.
Registration mark is scanned, and sensor level is adjusted. It will return
to ARMS SETTING screen (3/5) once the adjustment is completed.
9
Press the [PAUSE/MENU] key
It will return to default screen.
) keys and move the tool
5-30
Supplement
It will return to ARMS SETTING screen (3/5)
without changing the settings when you
press the [ESC] key (CANCEL).
Supplement
It will return to ARMS SETTING screen (3/5)
after setting the sensor level to default when
you press the [2] key (DEFAULT).
Supplement
•
It will return to SENSOR ADJUST screen
without changing the settings when you
press the [ESC] key (CANCEL).
•
It may not scan correctly even after the
adjustment depending on the condition of
the media. See "Manual Position Adjust"
if the sensing does not complete properly.