GRAPHTEC FCX4000 SERIES User Manual page 86

The area necessary to scan the registration mark when the Mark Distance is set is as following:
Do not print in the shaded area shown in the Figure below.
MARK TYPE 1
a
MARK TYPE MIRROR 1
a
a
Cutout area
MARK TYPE 1
a
a
MARK TYPE MIRROR 1
a
a
Cutout area
Supplement
•
See "Setting Shape (Pattern) of Registration Mark" to change the shape (pattern) of the registration mark.
•
See "Setting Mark Distance" for setting Mark Distance.
•
It may mistakenly sense as registration mark if there is anything else plotted within the registration mark scanning area.
Adjust the "MARK DISTANCE" so it can scan the registration mark correctly. (See "Setting Mark Distance")
•
Clean any dirt or foreign objects from the media. Any dirt or foreign object might be scanned mistakenly as registration
mark.
•
Plot the registration mark in contrast easy to scan, such as black lines on white background. Adjust the scanning level of
the sensor if you need to use the colored or glossy media. (See "Adjusting the Sensor Level ")
For 3POINTS
MARK TYPE 2
a
a
a
MARK TYPE MIRROR 2
a
a
Cutout area
For 4POINTS
MARK TYPE 2
a
a
a
a
MARK TYPE MIRROR 2
a
a
a
a
Cutout area
5-4
MARK TYPE 3
a
a
a
MARK TYPE 4
a
a
a
a=6 mm
Registration scanning area
MARK TYPE 3
a
a
MARK TYPE 4
a
a
a
a=6 mm
Registration scanning area
a
a