Outline Of Manual Position Adjust; Setting Of Mark Scan Mode And Number Of Adjustment Marks - GRAPHTEC FCX4000 SERIES User Manual

6.1
Outline of Manual Position Adjust
With manual position adjust, tilt of the axes are adjusted using the 2POINTS, 3POINTS, or 4POINTS adjustment
marks (grits or registration marks) as a standard. The distance between each points can also be entered to adjust
the distance.
Move the tip of each tool to the appropriate point.
Use the media with prints (adjustment marks such as grits or registration marks) necessary to get XY axes and
origin point.
Setting of MARK SCAN MODE and Number of Adjustment Marks
To perform the AXIS ALIGNMENT, set the MARK SCAN MODE to "AXIS ALIGNMENT".
Select the number of the registration marks (adjustment marks) from 2 POINTS, 3 POINTS, or 4 POINTS when
the MARK SCAN MODE is set to "AXIS ALIGNMENT". Position of each adjustment marks are as following.
First point or origin point
Third point
First point or origin point
2 POINTS
Second point
4 POINTS
Fourth point
Second point
Third point
First point or origin point
6-2
3 POINTS
Second point