13
Press the [1] key (DURING DETECTION) in ARMS SETTING
screen (1/5).
Following message is displayed.
14
Press the POSITION (
the adjustment point (adjustment registration mark).
15
Confirm the position of the tool, and if it is OK, press the
[ENTER] key (SET).
Once all the adjustment marks are specified, DISTANCE entry screen is
displayed.
16
Press the POSITION (
on the data.
) key and match the tool tip to
) keys to set the original distance
6-5
Supplement
•
Repeat steps 14 and 15 if following
message prompting to move to the
adjustment mark is displayed.
•
Number to repeat steps 14 and 15 differs
depending on the specified number of the
adjustment marks. Follow the message that
is displayed.
•
It will return to default screen without
scanning when the [ESC] key (CANCEL)
is pressed.
Supplement
•
Measured distance is displayed in the top
line in the DISTANCE input screen. Input
value (initially same as measured value)
is displayed under that.
•
If the input value is not changed, it
will assume that there is no difference
between measured distance and the
distance in the data.
•
Digits of settings can be changed by
pressing the [SLOW] key.