Table of Contents
Advertisement
3
PARTS NAMES and FUNCTIONS
3.2
Attaching a Tool
Attach a tool (cutter pen, plotter pen) to the plotter
Attaching a Tool
When mounting the tool in the tool holder, push the tool all the way into the holder until its flange contacts
the upper part of the holder and then tighten the screw firmly. To prevent injury, avoid touching the tool
immediately after the cutting plotter is turned on or whenever the tool is moving It is explained here using
cutter pen as an example
(1) Loosen the pen holder screw
(2) While pushing the tool holder in the upward direction, push the tool all the way into the holder until its
flange contacts the upper part of the holder.
• When pushing the tool holder with your fingers, the blade tip may be protruding. Take care not to cut
your fingers.
Tool holder
Bracket to hold tool
Flange
For half cutting
(backward)
For cutting out
(forward)
FC9000-UM-251-9370
3-3
Advertisement
Table of Contents
