Attaching A Tool - GRAPHTEC FC9000 Series User Manual

2.2

Attaching a Tool

Attach a tool (cutter plunger, plotter pen) to the plotter.
Attaching a tool
When mounting the tool in the tool holder, please note the following.
Push the tool all the way into the holder until its flange contacts the upper part of the holder and then tighten
the screw firmly.
whenever the tool is moving.
It is explained here using cutter plunger as an example.
CAUTION
Supplement
When using with half cutting and plotter pen, set the seal in Tool Holder (backward), and when using cutting out (perforated
cut), set the seal in Tool Holder (forward).
Cutting out means that the media is cut out completely.
Mounting
1
Loosen the tool holder screw.
Backing
sheet
Bracket to hold tool
Top
2-5
Tool holder
Tool holder
Bracket to hold tool