Attaching A Tool - GRAPHTEC CE6000 SERIES Setup Manual

1. Attaching a Tool

Attach a tool (cutter plunger, plotter pen) to the plotter.
Attaching a Tool
When mounting the tool in the tool holder, please note the following.
•
Push the tool all the way into the holder until its flange contacts the upper part of the holder and then tighten the screw
firmly.
•
To prevent injury, avoid absolutely touching the tool immediately after the cutting plotter is turned on or whenever the tool
is moving.
For details, see "Attaching a Tool" on in User's Manual.
It is explained here using cutter plunger as an example.
CAUTION
When pushing the tool holder with your fingers, the blade tip may be protruding. Take care not to cut your fingers.
Supplement
•
When using with half cutting and plotter pen, set the seal in Tool Holder 1 (backward), and when using cutting out (perforated cut), set
the seal in Tool Holder 2 (forward).
•
Cutting out means that the media is cut out completely.
•
Half cutting means that only the marking film is cut out, leaving the backing sheet uncut.
1
Loosen the tool holder screw.
2
While pushing up the tool holder, push until its flange completely touches
the upper part of the holder.
Tool holder 2
(Forward : Using
cutting)
Setting up the Plotter main unit
Bracket to hold tool
Top
Bracket to
hold tool Flange
Tool holder
Tool holder
Bracket to hold tool
Tool holder
Tool holder 1
(Backward : Half cutting/Plotting Pen)
3
Supplement
When using with half cutting and plotter pen,
set the seal in Tool Holder 1 (backward), and
when using cutting out (perforated cut), set the
seal in Tool Holder 2 (forward).