Table of Contents
Advertisement
Item
Configure an MVR port of the designated MVR VLAN as one of the following roles.
•
•
•
Port Role
Note: MVR source ports are not recommended to be overlapped with management VLAN
Select the port role by clicking the Role symbol to change the setting.
I indicates Inactive; S indicates Source; R indicates Receiver
The default Port Role is Inactive.
Enable the fast leave on the port.
Multicast snooping Fast Leave processing allows the MP1204-XT to remove an interface
from the forwarding-table entry without first sending out group specific queries to the
Immediate
interface. The VLAN interface is pruned from the multicast tree for the multicast group
Leave
specified in the original leave message. Fast-leave processing ensures optimal
bandwidth management for all hosts on a switched network, even when multiple
multicast groups are in use simultaneously. This processing applies to IGMP and MLD.
Configuration | IPMC Menus
The following sub-menus are under the IPMC menu.
•
IPMC | IGMP Snooping Menus
•
IPMC | MLD Snooping Menus
IPMC | IGMP Snooping Menus
The following pages are under the IGMP Snooping menu:
•
IPMC | IGMP Snooping | Basic Configuration
•
IPMC | IGMP Snooping | VLAN Configuration
•
IPMC | IGMP Snooping | Port Filtering Profile
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
Configuration | MVR (Continued)
Inactive: The designated port does not participate MVR operations.
Source: Configure uplink ports that receive and send multicast data as source ports.
Subscribers cannot be directly connected to source ports.
Receiver: Configure a port as a receiver port if it is a subscriber port and should only
receive multicast data. It does not receive data unless it becomes a member of the
multicast group by issuing IGMP/MLD messages.
ports.
on Page 123
on Page 127
on Page 124
on Page 125
on Page 126
Configuration | IPMC Menus
Configuration Pages - 123
Advertisement
Table of Contents
