Table of Contents
Advertisement
QoS | Queue Policing
Item
Rate
Unit
Flow Control
QoS | Queue Policing
This page allows you to configure the Queue Policer settings for all switch ports.
Item
Port
Enable
Rate
Unit
158 - Configuration Pages
Configuration | QoS | Port Policing (Continued)
Controls the rate for the policer. The default value is 500. This value is
restricted to 100-1000000 when the Unit is kbps or fps, and it is restricted to 1-
3300 when the Unit is Mbps or kfps.
Controls the unit of measure for the policer rate as kbps, Mbps, fps or kfps.
The default value is kbps.
If flow control is enabled and the port is in flow control mode, then pause
frames are sent instead of discarding frames.
Configuration | QoS | Queue Policing
The port number for which the configuration below applies.
Enable or disable the queue policer for this switch port.
Controls the rate for the queue policer. This value is restricted to 100-3276700
when Unit is kbps, and 1-3276 when Unit is Mbps. The rate is internally
rounded up to the nearest value supported by the queue policer.
This field is only shown if at least one of the queue policers are enabled.
Controls the unit of measure for the queue policer rate as kbps or Mbps.
This field is only shown if at least one of the queue policers are enabled.
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
Advertisement
Table of Contents
