System | Ntp - Comtrol RocketLinx MP1204-XT User Manual

System | NTP

Item
Network
Mask Length
Gateway
Next Hop VLAN(Only
for IPv6)
Buttons (Other button are discussed on
System | NTP
Use this page to configure NTP.
Item
Mode
40 - Configuration Pages
Configuration | System | IP Configuration (Continued)
The destination IP network or host address of this route. Valid format is dotted
decimal notationor a valid IPv6 notation. A default route can use the value
0.0.0.0or IPv6 :: notation.
The destination IP network or host mask, in number of bits (prefix length). It
defines how much of a network address that must match, in order to qualify for
this route. Valid values are between 0 and 32 bits respectively 128 for IPv6
routes. Only a default route has a mask length of 0 (as it matches anything).
The IP address of the IP gateway. Valid format is dotted decimal notation or a
valid IPv6 notation. Gateway and Network must be of the same type.
The VLAN ID (VID) of the specific IPv6 interface associated with the gateway.
The given VID ranges from 1 to 4094 and is effective only when the
corresponding IPv6 interface is valid.
If the IPv6 gateway address is link-local, it must specify the next hop VLAN for
the gateway.
If the IPv6 gateway address is not link-local, system ignores the next hop VLAN
for the gateway.
Page 34)
Click to add a new IP interface. A maximum of 8 interfaces is supported.
Click to add a new IP route. A maximum of 32 routes is supported.
Configuration | System | NTP
Indicates the NTP mode operation. Possible modes are:
• Enabled: Enable NTP client mode operation.
• Disabled: Disable NTP client mode operation.
RocketLinx MP1204-XT User Guide: 2000644 Rev. A