LLDP Configure Commands
LLDP Configure Commands
This subsection contains LLDP Configure commands.
lldp holdtime
Sets LLDP hold time (The neighbor switch will discarded the LLDP
Description
information after \"hold time\" multiplied with \"timer\" seconds ).
Syntax
lldp holdtime <2-10>
Name
Parameter
<2-10>
lldp med
Description LLDP MED
Syntax
LLDP MED
Name
datum
fast
Parameter
location-tlv
media-vlan-policy
372 - Command Line Interface (CLI)
Description
Holdtime 2-10 seconds
Description
Datum (geodetic system) type
•
nad83-mllw: Mean lower low water datum 1983
•
nad83-navd88: North American vertical datum 1983
•
wgs84: World Geodetic System 1984
Number of times to repeat LLDP frame transmission at fast start
<v_1_to_10> : <1-10>
LLDP-MED Location Type Length Value parameter
•
altitude: Altitude parameter
•
civic-addr: Civic address information and postal information
•
elin-addr: Emergency Location Identification Number, (for example,
E911 and others), such as defined by TIA or NENA.
•
latitude: Latitude parameter
•
longitude: Longitude parameter
Use the media-vlan-policy to create a policy, which can be assigned to
an interface
<Index : 0-31> : Policy id for the policy which is created
RocketLinx MP1204-XT User Guide: 2000644 Rev. A