Related Manuals for Comtrol Rocketlinx ES8108-GigE
Summary of Contents for Comtrol Rocketlinx ES8108-GigE
- Page 1 ROCKETLINX ES8105/8108 Industrial Full Gigabit Ethernet Switch Quick Installation Guide ES8105-GigE | ES8108-GigE www.comtrol.com 2000533 Rev B...
- Page 2 Introduction The RocketLinx ES8105-GigE and ES8108-GigE are industrial Ethernet switches with full Gigabit ports that are backward compatible (10/100/1000BASE-TX). The ES8105-GigE has five Gigabit ports and the ES8108-GigE has eight Gigabit ports. The ES8105-GigE and ES8108-GigE are referred to as the switch in the remainder of the Guide unless model-specific information is required.
- Page 3 Grounding the Switch There is an earth ground screw on the bottom Earth Ground side of the switch. Connect the earth ground Screw screw of the switch to a grounding surface to ensure safety and prevent noise. It is not necessary to attach a ground wire if Earth Ground the DIN rail is grounded and the switch is mounted on the DIN rail.
- Page 4 Wiring the Alarm Relay The alarm relay contacts are in the middle of the terminal block connector. By inserting the wires and setting the DIP switch of the respective Port Alarm to ON, the alarm relay detects any port failures and forms a short circuit. The alarm relay is normally open. It closes if there is a port or power failure.
- Page 5 The following table shows the RJ45 pin-out assignments for the Ethernet ports. Connect one side of an Ethernet cable into any switch port and connect the other side to your attached device. The wiring cable types and maximum cable length are as follows. •...
- Page 6 Comtrol Customer Service You can use one of the following methods to contact Comtrol Corporation. Contact Method Web Address or Phone Number Support http://www.comtrol.com/pub/en/support ftp://ftp.comtrol.com/html/ES8105_GigE.htm Downloads ftp://ftp.comtrol.com/html/ES8108_GigE.htm Web Site http://www.comtrol.com Phone 763.957.6000...
Need help?
Do you have a question about the Rocketlinx ES8108-GigE and is the answer not in the manual?
Questions and answers