Table of Contents
Advertisement
Configuration | Mirroring
Item
VLAN ID
Reflector Port
Source VLAN(s) Configuration
Source VLANs
Port Configuration
Port
Source
Intermediate
Destination
172 - Configuration Pages
Configuration | Mirroring (Continued)
The VLAN ID points out where the monitor packet is copied to. The default VLAN
ID is 200.
The reflector port is a method to redirect the traffic to Remote Mirroring VLAN. Any
device connected to a port set as a reflector port loses connectivity until the Remote
Mirroring is disabled.
In the stacking mode, you need to select switch ID to select the correct device.
If you shut down a port, it cannot be a candidate for reflector port.
If you shut down the port which is a reflector port, the remote mirror function cannot
work.
Note: The reflector port needs to select only on Source switch type. The reflector port
needs to disable MAC Table learning and STP. The reflector port only
supports on pure copper ports.
The switch can supports VLAN-based Mirroring. If you want to monitor some
VLANs on the switch, you can set the selected VLANs on this field.
Note: The Mirroring session shall have either ports or VLANs as sources, but not
both.
The logical port for the settings contained in the same row.
The following mirror modes are available.
•
Disabled Neither frames transmitted nor frames received are mirrored.
•
Both Frames received and frames transmitted are mirrored on the Intermediate/
Destination port.
•
Rx only Frames received on this port are mirrored on the Intermediate/
Destination port. Frames transmitted are not mirrored.
•
Tx only Frames transmitted on this port are mirrored on the Intermediate/
Destination port. Frames received are not mirrored.
This check box is designed for Remote Mirroring.
The intermediate port is a switched port to connect to other switch.
Note: The intermediate port needs to disable MAC Table learning.
This check box is designed for mirror or Remote Mirroring.
The destination port is a switched port that you receive a copy of traffic from the
source port.
Note: On mirror mode, the device only supports one destination port. The
destination port needs to disable MAC Table learning.
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
Advertisement
Table of Contents
