Table of Contents
Advertisement
PoE | PoE
Item
Power Management Mode
In Actual Consumption mode the ports are shut down when the actual power
consumption for all ports exceeds the amount of power that the power supply can
Actual
deliver or if the actual power consumption for a given port exceeds the reserved
Consumption
power for that port. The ports are shut down according to the ports priority. If two
ports have the same priority the port with the highest port number is shut down.
In Reserved Power mode the ports are shut down when total reserved powered exceeds
the amount of power that the power supply can deliver. In Reserved Power mode the
Reserved Power
port power is not turned on if the PD requests more power than available from the
power supply.
PoE Power Supply Configuration
For being able to determine the amount of power the PD may use, it must be defined
Primary Power
what amount of power a power source can deliver.
Supply (W)
Valid values are in the range 0 to 240 Watts.
PoE Port Configuration
Port
This is the logical port number for this row.
•
Mode
•
•
•
Operation
•
The priority is used in the case where the remote devices require more power than
the power supply can deliver. In this case, the port with the lowest priority is turned
off starting from the port with the highest port number.
Priority
•
•
•
The Maximum Power value contains a numerical value that indicates the maximum
Maximum Power
power in watts that can be delivered to a remote device. Valid ranges are 0 to 30 W.
140 - Configuration Pages
Configuration | PoE | PoE (Continued)
Disable - PoE disabled for the port.
Enable - Enables PoE for the port.
Schedule - Enables PoE for the port by scheduling.
802.3af - Sets PoE protocol to IEEE 802.3af.
802.3at - Sets PoE protocol to IEEE 802.3at.
Low - The lowest priority
High - The medium priority
Critical - The highest priority
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
Advertisement
Table of Contents
