Table of Contents
Advertisement
Spanning Tree | Bridge Settings
Spanning Tree | Bridge Settings
Use this page to configure STP system settings. These settings are used by all STP Bridge instances in the
MP1204-XT.
Item
Basic Settings
The MSTP / RSTP / STP protocol version setting. Valid values are STP, RSTP and
Protocol Version
MSTP.
Controls the bridge priority. Lower numeric values have better priority. The bridge
priority plus the MSTI instance number, concatenated with the 6-byte MAC address of
the switch forms a Bridge Identifier.
Bridge Priority
For MSTP operation, this is the priority of the CIST. Otherwise, this is the priority of
the STP/RSTP bridge
The delay used by STP Bridges to transit Root and Designated Ports to Forwarding
Forward Delay
(used in STP compatible mode). Valid values are in the range 4 to 30 seconds.
The maximum age of the information transmitted by the Bridge when it is the Root
Max Age
Bridge. Valid values are in the range 6 to 40 seconds
This defines the initial value of remaining Hops for MSTI information generated at the
Maximum Hop
boundary of an MSTI region. It defines how many bridges a root bridge can distribute
Count
its BPDU information to. Valid values are in the range 6 to 40 hops.
The number of BPDU's a bridge port can send per second. When exceeded,
Transmit Hold
transmission of the next BPDU is delayed. Valid values are in the range 1 to 10
Count
BPDU's per second.
Advanced Settings
Edge Port BPDU
Controls whether a port explicitly configured as Edge transmits and receives BPDUs.
Filtering
112 - Configuration Pages
Configuration | Spanning Tree | Bridge Settings
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
Advertisement
Table of Contents
