Table of Contents
Advertisement
LLDP | LLDP-MED Neighbors
LLDP | LLDP-MED Neighbors
This page provides a status overview of all LLDP-MED neighbors. The displayed table contains a row for each
port on which an LLDP neighbor is detected. This function applies to VoIP devices which support LLDP-MED.
Item
Port
The port on which the LLDP frame was received.
LLDP-MED Devices are comprised of two primary Device Types: Network Connectivity
Devices and Endpoint Devices.
LLDP-MED Network Connectivity Device Definition
LLDP-MED Network Connectivity Devices, as defined in TIA-1057, provide access to the
IEEE 802 based LAN infrastructure for LLDP-MED Endpoint Devices. An LLDP-MED
Network Connectivity Device is a LAN access device based on any of the following
technologies:
1. LAN Switch/Router
2. IEEE 802.1 Bridge
3. IEEE 802.3 Repeater (included for historical reasons)
4. IEEE 802.11 Wireless Access Point
Device Type
5. Any device that supports the IEEE 802.1AB and MED extensions defined by TIA-1057
and can relay IEEE 802 frames via any method.
LLDP-MED Endpoint Device Definition
LLDP-MED Endpoint Devices, as defined in TIA-1057, are located at the IEEE 802 LAN
network edge, and participate in IP communication service using the LLDP-MED
framework.
Within the LLDP-MED Endpoint Device category, the LLDP-MED scheme is broken into
further Endpoint Device Classes, as defined in the following.
Each LLDP-MED Endpoint Device Class is defined to build upon the capabilities defined
for the previous Endpoint Device Class. For example, any LLDP-MED Endpoint Device
claiming compliance as a Media Endpoint (Class II) also supports all aspects of TIA-1057
applicable to Generic Endpoints (Class I), and any LLDP-MED Endpoint Device claiming
compliance as a Communication Device (Class III) also supports all aspects of TIA-1057
applicable to both Media Endpoints (Class II) and Generic Endpoints (Class I).
238 - Monitor Pages
Monitor | LLDP | LLDP-MED Neighbors
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
Advertisement
Table of Contents
