Table of Contents
Advertisement
Configuration | Ports
Item
Configured Link
Speed
Flow Control
Maximum Frame
Size
Excessive Collision
Mode
48 - Configuration Pages
Configuration | Ports (Continued)
Selects any available link speed for the given switch port. Only speeds supported by
the specific port is shown. Possible speeds are:
•
Disabled - Disables the MP1204-XT port operation.
•
Auto - Port auto negotiating speed with the link partner and selects the highest
speed that is compatible with the link partner.
•
10Mbps HDX - Forces the cu port in 10Mbps half duplex mode.
•
10Mbps FDX - Forces the cu port in 10Mbps full duplex mode.
•
100Mbps HDX - Forces the cu port in 100Mbps half duplex mode.
•
100Mbps FDX - Forces the cu port in 100Mbps full duplex mode.
•
1Gbps FDX - Forces the port in 1Gbps full duplex.
When Auto Speed is selected on a port, this section indicates the flow control
capability that is advertised to the link partner.
When a fixed-speed setting is selected, that is what is used. The Current Rx column
indicates whether pause frames on the port are obeyed, and the Current Tx column
indicates whether pause frames on the port are transmitted. The Rx and Tx settings
are determined by the result of the last Auto-Negotiation.
Check the configured column to use flow control. This setting is related to the
setting for Configured Link Speed.
Enter the maximum frame size allowed for the MP1204-XT port, including FCS.
Configure port transmit collision behavior.
•
Discard: Discard frame after 16 collisions (default).
•
Restart: Restart back-off algorithm after 16 collisions.
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
Advertisement
Table of Contents
