Security | Switch | Access Management - Comtrol RocketLinx MP1204-XT User Manual

Security | Switch | Access Management

Configure access management table on this page. The maximum number of entries is 16. If the application's
type matches any one of the access management entries, it allows access to the MP1204-XT.
Item
Mode
Delete
VLAN ID
Start IP address
End IP address
HTTP/HTTPS
SNMP
TELNET/SSH
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
Configuration | Security| Switch | Access Management
Indicates the access management mode operation. Possible modes are:
• Enabled: Enable access management mode operation.
• Disabled: Disable access management mode operation.
Check to delete the entry. It is deleted during the next save.
Indicates the VLAN ID for the access management entry.
Indicates the start IP address for the access management entry.
Indicates the end IP address for the access management entry.
Indicates that the host can access the MP1204-XT from HTTP/HTTPS interface
if the host IP address matches the IP address range provided in the entry.
Indicates that the host can access the MP1204-XT from SNMP interface if the
host IP address matches the IP address range provided in the entry.
Indicates that the host can access the MP1204-XT from TELNET/SSH interface
if the host IP address matches the IP address range provided in the entry.
Click to add a new access management entry.
Security | Switch | Access Management
Configuration Pages - 59